Mechanical Steel Shear

Thu, May 20, 2010

Share...

Mechanical Steel Shear pre-assembly at Galbiati Group workshop. The blades are actuated by the coordinated rotation of two eccentric shafts, driven by two independent gear trains, each one powered by 900 kW electric motors at 1000 rpm. Total weight: more than 650 ton.

Rocking shears at the end of pre-assembly in the Galbiati Group workshop

After pre-assembly and test at Galbiati Group workshop, the entire mechanical steel shear was dismantled in sub-assemblies and transported by sea to its final destination in India. On site, it was reassembled by qualified personnel and immediately entered production, to the complete satisfaction of the local engineers.

Rocking shears at the end of pre-assembly in the Galbiati Group workshop

The image below shows a detail of the preliminary assembly phase and tooth contact pattern check on the eccentric shaft coordinated rotation gear trains. Take special note of the oil film bearings and the thrust bearings, sized to support the enormous peak loads during the cutting phase.

Rocking shears at the end of pre-assembly in the Galbiati Group workshop

Rocking shears at the end of pre-assembly in the Galbiati Group workshop

The image shows machining of the welded steel lower frame on a 120-ton rotating table CNC boring machine.

See the video

See also:

Strip Pendular Shear

Hydraulic Rocking Shears

Gear Trains for Mechanical Rocking Shears

Category: Steel Sheet Shears

Leave a Reply

Antennas and Radio Telescopes automotive industry Azimuth rotation segments Base Plates Best Supplier Siemens Vai blanking cut to length lines Brushing machines CAM2 Laser Tracker Xi system CNC Coil Processing Lines components for nuclear energy Crop shear Crop Shears Cut-to-Length Lines Cutter head Cutting Sheet CWIEME Berlin 2012 Fair Cwieme Berlin 2015 energy Energy production Erector for TBM Feeding Lines gear trains Hannover Messe 2011 hydraulic press mechanical press oil film bearings Packing Lines Pendular Shears Piping rolling mills Pre-assembly rolling mills Presses for blanking lamination Process Lines radio telescope Rails revamping complete lines revamping single machine Rocking shears Rolling mills Segment Erector for TBM slitting lines Steel Sheet Shears TBM tensio levelling system Tunnel Boring Machines
Contatto Skype

GalbiatiGroup

Form
CASE HISTORY

Galbiati Group - Engineering & Machining

23848 Oggiono (Lc) Via Cà Bianca Pascolo, 26 Italy | Fax +39 341.2633300 | s.origgi@galbiatigroup.it
P.Iva: 03301540963 | Capitale sociale: 500.000 euro | REA: MI-1665349
Copyright © 2010 Custom-built Machines. All rights reserved.
All the photos are under licence Creative Commons Attribution-Noncommercial-No Derivative 
Privacy Policy - Legal information

Galbiati Group

LiveZilla Live Chat Software